Sebatron vmp Bedienungsanleitung PDF herunterladen (Seite 6)

Output Meter

Options

Power Switch

Meter Source

THORAX

Meter

The metering section allows you to gain an insight into the internal

operations of Thorax. The amount of gain reduction occurring in the compressor

can be indicated by switching the Meter Source to GR. The meter should then sit

at 0dB and the meter markings will indicate the amount (in dB) of gain reduction.

With the Meter Source set to O/P the O/P meter options become active.

These controls give you the choice of preamp or main output levels over 3

possible ranges.

The medium range is calibrated to 0dBu at the XLR balanced outputs.

The other settings enable you to monitor both the upper ranges of modern high

headroom equipment and the lower signal levels possible with 24 bit recording.

Always remember that the VU specication was developed with tape in

mind, and as a result only represents a fraction of the dynamic range possible

with todays digital recordings. All Sebatron products are designed with this wide

dynamic range in mind and the limitations of the meter in no way represent the

limitations of the unit. Because we use no integrated circuits, there is no hard

clip point, only a gradual increase in valve warmth and then distortion that can

be musically useful. What this means is that if the meter is slamming against the

stops but the sound is just what you want, switch the meter to a lower level or to

GR and follow your ears. The input meters of your recording device show the only

truly important levels.

6 7

1 2 3 4 5 6 7 8 9 10 11 12 13

Keine Kommentare

Sebatron vmp Bedienungsanleitung Seite 6