Sebatron vmp Bedienungsanleitung PDF herunterladen (Seite 7)

Voltage

Selector

Switch

Fuse

1.25A

Slow

Mains

Input

Main XLR

and TRS

Outputs

Transformer

Balanced XLR

Microphone

Preamp Input

Preamp XLR and

TRS Outputs

Sidechain

Input

Compressor

Insert/Input

120v 240v

Tip = Compressor Line

In/Receive

Ring = Preamp-Out/Send

Tip = Comp Key Receive

Ring = Comp Key Send

The rear panel of Thorax contains most of the input and outputs and the

IEC mains connector. The input voltage range is switchable between 110-120V

and 220-240V. Make sure it is set correctly before you switch the unit on!

Sebatron units are built tough and usually survive abuse, but we don’t guarantee

it.

The sidechain input interrupts the audio signal being sent to the level

detection circuitry which controls the compressor. This is normally the audio that

is being compressed, but through the use of the sidechain you can either process

the signal and then send it back or introduce an entirely different signal. See

Usage for more details.

The Main and Preamp XLR and TRS outputs are fully balanced by

discrete Class A driver circuits. They follow the industry standard Pin 2 Hot pinout.

The Compressor Insert/Input is a TRS jack that normally sends the

preamp output to the compressor input. You can

use an insert splitter cable to further process the signal between the preamp and

compressor, e.g. with further EQ.

This insert also allows you to use the pre and compressor sections

individually. Use a standard unbalanced patch cable or guitar lead to inject a

signal into the compressor. There is quite a bit of gain available through use of the

Compression Drive switch, making it possible to run a vocal microphone through

the pre and a guitar or bass through the comp.

THORAX

Rear Panel

8 9

1 2 3 4 5 6 7 8 9 10 11 12 13

Kommentare zu diesen Handbüchern

Keine Kommentare

Sebatron vmp Bedienungsanleitung Seite 7

Kommentare zu diesen Handbüchern